Description DC 12V 24V LED Digital Time Delay Relay Module Programmable Timer
Relay Control Switch Timing Trigger Cycle with Case for Indoor 213
*Description:* 
1. New upgrades to simplify,to meet customer needs. 
2. Increase the supply anti-reverse function. 
3. The use of opto isolated input and output, enhanced anti-jamming capabilit
   consumption. 
4. Set parameter after power for ever memories. 
5. Signal terminal voltage signal can be maintained for a longtime. 
6. to ensure stability, industrial grade board, class PLC.
*Specifications:* 
1. Size: 64.2mm*34.8mm*18.5mm. 
2. Relay Specifications: AC 220V 10A or DC 30V 10A. 
3. Quiescent Current: 20mA, Operating Current: 50mA. 
4. Working voltage: 10~16V.
5. Signal voltage: 4V~20V.
6. life: about 100,000 times, Working temperature:-40~85'C. 
Working mode selection:
After power on, long press K12 seconds later into the select function mode,
P1-1~P1-4 for choose. 
P1-1 operating modes: a signal to trigger relay, time is up, the relay
disconnect users, You can set relay time T, click K2 the hundred digital tube
starts flashing, then press K3, the hundred digital change; click K2 ten
digital tube starts flashing, then press K3, ten digit changes; click K2 bit
digital tube starts flashing, then press K3, single-digit change; then click
K2, ; digital pipe does not blink, then press the K3, shifting the decimal
point, the decimal point in a bit indicates 0-999 minutes in ten represents 0
to 99. 9 seconds without a decimal point represents 0-999 seconds; good choice,
bringing the time setting is completed. Short press K1, enter function
offine-tuning settings, trigger the default delay period is invalid, press K1,
during the delay trigger active (re-timing), clickon the K1, during the delay
reset (timer turned off, the relay reset) press again to repeat the default
settings for the first time.
P1-2 operating modes: Asignal trigger, digital countdown begins, X seconds
after, there lay open Y seconds, then close. Users can set the relay time X, Y;
P1-1 different time settings similar to the blue lights that set the relay
time, blue light indicates setting relay off time. Short press K1, enter
function offine-tuning the set, the default trigger is invalid during the
delay, press K1, during the delay trigger active (re-timing), then click the
first repeat default settings. 
P1-3 operating modes: Open X seconds, disconnect Y seconds, infinite loop.
Users can set the relay time X, Y; time setting similar to P1-2. Short press
K1, enter function offine-tuning set, The default function is:set up an
electric circuit the relay first open, press the K1, there lay first close.
Press again to repeat the default functionality. 
P1-4 operating modes: a signal to trigger the relay open but do not start the
timer, when the trigger signal disappears, digital count down begins, X time
after, the relayclose; During the delay, again to the signal, digital count
down canceled, stays energized, the signal disappears, restart count down;
(equivalent to release the button to start timing, commonly used in
power-off delay). Users can set the relay time X; time setting similar to P1-1.